Zinc Cut Wire Shots
We manufacture complete range of Zn Cut Wire Shots in size ranging
from 0.4mm to 1.6mm size in both As cut and Conditioned form. We have
ready stocks of various sizes available with us.
We offer a qualitative range of Zinc Cut Wire Shots. Available at
competent rates, our products reduce wear and tear on blasting equipment.
These Zinc cut wire shots are softer than stainless steel cut wire or
cast products. Zinc cut wire shot is available in different sizes.Zinc
Cut Wire Shot is produced by cutting zinc wire into pellets, the length
equal to the diameter of the wire. Zinc Cut Wire is used mainly for
sand removal, deburring and deflashing of non ferrous components. Zinc
Cut Wire is also available in a conditioned form which is used as a
longer lasting alternative to cast zinc shot. Deburring and
deflashing of aluminium and zinc castings and die-castings. Removal of
sand from sand castings. Removal of parting lines and stains from non
ferrous castings. Removal of water wrinkle from aluminium die castings
and providing a luster satin type finish. Zinc Cut Wire provides
temporary corrosion protection to ferrous parts blasted with it. A very
thin layer, up to 1.3μm thick is deposited onto the surface of the part.Specifications:
AbrasiveZINC CUT WIREChemical CompositionZn 99.99% or upFe 0.005% or lessHardness36-51 HVAvailable Size0.6 x 0.6 mm0.8 x 0.8 mm1.0 x 1.0 mm1.2 x 1.2 mm2.5 x 2.5 mm3.0 x 3.0 mm
We manufacture complete range of Zn Cut Wire Shots in size ranging
from 0.4mm to 1.6mm size in both As cut and Conditioned form.
